![]() ![]() If you don’t want that, then edit the start gcode for each material to replace the 4 gcode lines starting with “G1 Z0.6 E0 F125” with a single line “G1 E0 F125” (these four lines are near the end of the file, just before the final “G92 E0” line). The start gcode includes a “priming blob” extruded near the left-front washer. If you don’t have the second wiper, you can either ignore the extra wipe motion (which will occur “in air” behind the original pad, not hurting anything), or you will need to remove the (6) lines marked with “ -” to eliminate the second wipe sequence from the start Gcode for each material. That is designed to work with a dual wiper mount ( ). The start gcode for each material contains an extra wipe sequence located just behind the standard wipe pad. Change Y173 to Y174, change Y171 to Y172, Y181 to Y182, and Y181.5 to Y182.5 in the start script for each material. ![]() If you use older firmware (including early 1.1.5.xx releases), you will need to increase the Y coordinate by 1 on all the wiping lines. That effectively changed the center of the wiper pad (reduced by 1mm) in new firmware, and these scripts expect that new location. (3) Newer 1.1.5.xx releases changed Y_Max from 191 to 190 and Y_Min from -6 to -7. For older releases (including early 1.1.5.xx releases), change those X-2 references to X1 for each Material so it doesn’t try to move the toolhead below X_Min. (2) Newer 1.1.5.xx releases changed X_Min from 0 to -3, and this start script positions the head to X-2 in multiple lines. Older 1.1.5.xx releases, and pre-1.1.5 releases used 115400, so you’d need to change that (“Edit Process Settings, G-Code, Baud rate”). (1) The baud rate for newer 1.1.5.xx releases is 250000, so that’s what this file contains. Otherwise, to use this profile with firmware earlier than 1.1.5.68: If you have an older firmware, I recommend updating to at least 1.1.5.68. ![]() This particular Simplif圓D profile is for a Lulzbot Mini with firmware 1.1.5.68 or later (tested up through 1.1.8.4). Find the line in the Starting Script “G1 E-15 F150” and change the -15 to -30. If you have a Flexistruder or Standard Extruder, you will need to make one change in the start Gcode for each material. This particular Simplif圓D profile is for a Lulzbot Mini with Aerostruder. I’ve gotten some other inquiries about this, so I’m just going to post the file here for anyone who wants it – WITH SOME CAVEATS AND EXPLANATIONS regarding what needs to be changed based on what Firmware and Extruder is being used. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |